Set-Up Off the Machine (V-Block)

1. Measure "L" length of Rotary Broach and record.

2. Scribe "L" measurement on setting plug and insert into Rotary Broach Tool Holder.

3. Slightly loosen two (2) hex nuts located on flange of Rotary Broach Tool Holder then place into a V-block. Lightly snug V-block clamp.

4. Set indicator to scribed "L" line on setting plug.

5. Tape live spindle and housing together to rotate tool holder as one piece. Using six (6) adjusting set screws, indicate tool holder to a maximum of .001 total indicator reading. (T.I.R.)

Final Step: Lock two (2) hex nuts; snug all six (6) sadjusting screws against studs. Recheck against possible movement, insert Rotary Broach into Rotary Broach Tool Holder, and tighten locking nut with spanner wrench.

You're ready to begin rotary broaching.

Click Here to Watch the Adjustable Tool Holder Set-Up in a V-block

Set-Up on the Machine

1. Measure "L" length of Rotary Broach and record.

2. Scribe "L" measurement on setting plug and insert into Rotary Broach Tool Holder. (We recommend grinding a flat on the shank portion of the tool holder that will correspond to the clamping bolts in your turret. This will reduce the likelihood of the holder spinning in the machine.)

 

3. Mount the Rotary Broach Tool Holder in the turret and position the tool holder so that the cutting portion of the Rotary Broach ("L" length) is as close to the work zero point as possible.

4. Slightly loosen two (2) hex nuts located on flange of Rotary Broach Tool Holder.

5. Mount the magnetic base dial indicator on the chuck. Using six (6) adjusting set screws, indicate tool holder to a maximum of .001 total indicator reading (T.I.R.) .This is done by rotating the chuck, NOT the Rotary Broach (using a telescoping inspection mirror is recommended).

Final Step: Lock two (2) hex nuts; snug all six (6) adjusting screws against studs. Recheck against possible movement, insert Rotary Broach into Rotary Broach Tool Holder, and tighten locking nut with spanner wrench.

You're ready to begin rotary broaching.

Click Here to Wtach the External Adjustable Tool Holder Set-Up in a Turret Lathe